NexStarCtl =========== This module implements the serial commands supported by the Celestron NexStar hand control. This applies to the NexStar GPS, NexStar GPS-SA, NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX, Advanced-GT, and CGE mounts. Communication to the hand control is 9600 bits/sec, no parity and one stop bit via the RS-232 port on the base of the hand control. INSTALLATION To install this module type the following: perl Makefile.PL make make test make install DEPENDENCIES Device::SerialPort Time::Local COPYRIGHT AND LICENCE Copyright (C) 2013-2014 by Rumen G.Bogdanovski This library is free software; you can redistribute it and/or modify it under the same terms as Perl itself, either Perl version 5.12.4 or, at your option, any later version of Perl 5 you may have available. The author assumes no liability or responsibility for damage or injury to persons or property arising from any use of this product. Use it at your own risk.